Washer Repair in National City

The washing machine has become an integral part of every home. It makes our work easier by doing our dirty work for us. It is much easier to throw the laundry in the washing machine and get it clean and semi-dry after a while. But any appliance is not durable and can break down. What to do in such a case? Just contact Chula Vista Appliance Service Center and our highly skilled technicians will take care of all your Washing Machine Repair in National City, CA.

The most common breakdowns of washing machines

The washing machine doesn't empty

In order to establish the exact cause, it is necessary that the technique was examined by a qualified specialist in Washing Machine Repair in National City, CA and suggested the best ways to fix the breakdown.

The causes may be the following:

• Clogged filters.
• Incorrectly set washing mode.
• The Drain hose is jammed.
• Failure of the control module. 
• Such a breakdown should be repaired only in specialized Washing Machine Repair in National City, CA, as it is a question of replacing the board or repairing it.
• Failure of the pump. 
• One of the most common causes. With such breakdowns, the machine may hum and not drain water. Such malfunctions occur due to the wear and tear of the pump (lifetime, on average, 3-5 years) or clogging with small debris.
• Breakdown of the water level sensor. 
• This element signals to the system the presence of water in the tank. If it is broken, it must be replaced.

The drum of the washing machine does not rotate

• Foreign object in the tank.
• The bearings are jammed due to wear and tear.
• Failure of electronic module.
• All these causes are subject to diagnosis and repair.

The washing machine rattles and makes a noise

• Foreign material entering the drum.
• Wear and tear of bearings and shock absorbers.
• Breakage of the tank suspension spring.
• Damage of counterweight or looseness of drum pulley.

Washing machine does not heat water

• Fired TEN (heating element). 
• The most common cause. If the tubular electric heater breaks down, it will have to be replaced - in most cases it cannot be repaired. Such work must be performed by a specialist.
• Breakdown of the temperature sensor.
• The control module has failed.
• The electronic module can fail due to voltage fluctuations, moisture, mechanical damage or time. Repair or replacement of the module will help to solve this problem. 
• Wrong washing mode selected.
• Washing machine is leaking, leaking
• Clogged detergent dispenser.
• Wear of seals, hose and cuffs.
• Damage to the drum.
• Wear of the drain pump, nipples, clamps, grease tank.

The Automatic knocks out when the washing machine is switched on

When the automatic machine kicks out, it is necessary to urgently call a master of the service center. With such a breakdown, you will not be able to wash without the risk of wiring fire or electrical short circuit. On-site diagnostics will identify the problem, and a National City Washing Machine Repair technician will fix it.

The washing machine does not turn on

• Fault in the cover of the door.
• No voltage to the socket.
• The control module is broken.  

Washing machine does not spin

This problem occurs when there is a breakage of the electronic module, failure of the tachometer, pump, drive motor winding, motor brush washing and failure of the water level sensor. For the exact determination of the breakdown and its elimination requires the assistance of a wizard and full-fledged Washing Machine Repair in National City, CA.

The washing machine shuts down and stops. It occurs in a number of reasons:

• • Failure of the TEN (heating element). 
  • If this part fails, you will need to replace the heating element of the washing machine, because it will not heat water and perform its functions. 
  • Malfunction of the motor.
  • Overloading or imbalance of the laundry.
  • Failure of the control module.
  • In this case, your machine is waiting for a breakdown and then you can't do without a National City Washing Machine Repairs and Service technician.

• The washing machine vibrates a lot.
• Wear and tear on parts.
• After a certain period of use, some parts may wear out and work less efficiently. In order to determine which of the parts requires repair or replacement, a diagnosis from a master washing machine technician is required.
• Overloading the laundry.
• Incorrect installation of the washing machine.
• Overloading the laundry.

Call a National City Washing Machine Repair and Service technician and he'll fix it.

We do not recommend doing the Washing Machine Repair yourself. When you contact Chula Vista Appliance Service Center, you will receive service from an experienced technician who will perform National City Washing Machine Repair and Service quickly and efficiently with a home visit.