Goodman Furnace Repair

Often, when faced with malfunctions and problems in the work of the gas furnace, users write them off as a defect, poor quality production. In fact, most people do not understand the peculiarities of the functioning of furnaces. And meanwhile many malfunctions arise due to wrong settings, unstable pressure or voltage. Therefore, it is better to contact a Chula Vista Appliance Service Center. The technicians at Goodman Furnace Repair in San Diego County will quickly fix and perform service.

Our company has been in the business of repairing gas furnaces since 2008.

Our Goodman Furnace Repair and Service technicians have over 15 years of experience.

Signs and types of breakdowns

Two-circuit and single-circuit boiler problems can vary:

• Intermittent malfunctions. Occur when external parameters do not match the unit's operating settings. For example, due to voltage surges in the network.
• Primary and secondary. Appearing on the screen for the first time, the code indicates a problem in the system. If the problem has not been eliminated, the error will appear a second time.
• Obvious and non-obvious. Upon inspection, you can see damage to the heat exchanger. But there are such problems - leaks, increased pressure - the causes of which can only be found by a specialist.
• Sudden and gradual. In the first case, the technique can shut down without preceding signs. In the second case, the causes are the wear and tear of parts.
• Let's consider the main signs of breakdowns, the causes of their occurrence, and the possibility of recovery with your own hands. All malfunctions will be repaired by Goodman Furnace Repairs gas furnace technicians.

Problems of gas furnaces

The burner does not ignite well, the flame goes out

The furnace does not turn on after the burner goes out. Why does it happen? The draft is broken. If there is no draft, furnaces with an open combustion chamber will not be able to maintain a stable flame. How do you check for drought? Light a match and bring it to the inspection window. If the flame deviates to the side, there is a draft, if it burns flat - no.

If there are problems with the air supply, you need to clean the chimney. This cannot always be done on your own, so you should call a Goodman Furnace Repair and Service shop.

It happens that the air flow is too strong, which causes the flame to go out. A damper is installed to regulate the flow. Chimney shaft icing interferes with air circulation. Remove the ice and insulate the outer pipes. If you cannot fix the problem yourself, you need to call Goodman Furnace Repair.

The draft sensor is defective

This causes the burner to take a long time to ignite. After ignition the flame goes out, the technique does not ignite again. To understand why the device does not work, you can connect the terminals with each other. If it was possible to ignite, then the problem is in the sensor, which needs to be replaced. Goodman Furnace Repair and Service technicians will come to your home and fix the problem.

Burner flame breakage

The flame is unstable when the unit is started, with tongues coming off the nozzles. The main problem is in the draft supply. With any changes in the greater or lesser direction, the heating will be unstable. This leads to triggering the flame sensor and shutting down the system. Therefore, it is recommended to periodically check the flu. Goodman Furnace Repair can help make this diagnosis.

Heating equipment requires preventive maintenance and inspection. This way, you will avoid many problems in operation. Don't delay repairs when you see signs of a malfunction. To avoid having to deal with water heating problems that arise, your gas furnace should undergo regular preventive cleaning at a dedicated Chula Vista Appliance Service Center. The technicians at Goodman Furnace Repair and Service will respond very quickly to your request and perform quality repairs on your equipment.